Ultimaker Job Submission

Ultimaker Job Submission

This page is used to show you how to use the job submission form for the Ultimaker 3D printer. Due to COVID, we are having to limit the amount of people in the makerspace at one time. For most machines, you have to be present to use the machine, however, the 3D printer can be submitted online and started by one of the managers in the space.

You can find the form here: https://docs.google.com/forms/d/e/1FAIpQLSdcgJJLBCYQulCYpyb5rhmhX4jy6RxEJj_oXetzfdyqzuElbg/viewform.

In this form, you will be inputting identifying information about you and your project. You must provide your name, email address, and UID, so we can identify you as a UMD affiliate and contact you in case anything goes wrong. Then you will provide information about your print so we can process it for you. You will have to provide a name for your print, the material type, the color, the weight in grams, the job time in hours, a link to where you found the 3D model (if applicable), and a google drive to the sliced file (after run through Cura or similar program).

Section by Section Help

This section will go over each question in case there is any confusion and to tell you why we need it.

Forewarning

If you enter incorrect information or are unresponsive for questions, we reserve the right to delay or cancel your print. Leaving your print in the space for too long after the print has finished might result in you losing your print. We will likely email you once your print is done and you should pick it up within a week or two.